1. Print two stencils, then enlarge if you like by photocopying at 200 percent. Cut out stencils. Using a pencil, trace both stencils onto a large piece of black foam board, available at craft stores.
2. Using an X-acto No. 1 Precision Kinfe, cut the foam board in half in between the two candelabra tracings. Place halves on a large piece of cardboard or a cutting board (to avoid damaging your table). Carefully cut out each candelabra piece and then fit them together in an ‘X’ using slots.
|Click here for the candelabra stencil.|